Installation
Yardian can provide a 24VAC power supply for wireless sensor receiver using a spare zone terminal. Please make sure the receiver of your wireless sensor is using a 24VAC power supply.
- Disconnect power to the Yardian.
- Attach receiver control wires (orange wires in the picture) to the sensor input terminals on the Yardian.
- Attach receiver power/common wires to the spare zone and COM terminal.
- Connect power to the Yardian.
24VAC power supply setup
1. Go to the Yardian Device Settings:
2. Specify a spare zone as the power supply.
3. Please note that you need to enable the spare zone first from the Yard tab for the
Rain sensor setup
1. Go to the Yardian Device Settings:
2. Click Rain Sensor and specify the type of your sensor - Normally Closed (most common) or Normally Open.
3. Run a zone using Instant Control for testing.
Comments
0 comments
Article is closed for comments.